Dell PowerEdge T100 Hardware Owner's Manual - Page 54
Installing a Diskette Drive, Remove the 3.5-inch insert on the front drive bezel. See Removing an
View all Dell PowerEdge T100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
10 Reconnect the system to the electrical outlet, and turn on the system and attached peripherals. Installing a Diskette Drive CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. Before you begin this procedure, review the safety instructions that came with the system. 1 Turn off the system and attached peripherals, and disconnect the system from the electrical outlet. 2 Open the system. See "Opening the System" on page 47. 3 Unpack the replacement diskette drive, and prepare it for installation. 4 Check the documentation for the drive to verify that it is configured for your system. 5 Remove the front drive bezel. See "Removing the Front Drive Bezel" on page 49. 6 Remove the 3.5-inch insert on the front drive bezel. See "Removing an Insert on the Front Drive Bezel" on page 50. 7 Remove the four shoulder screws from the back of the insert. See Figure 3-4; the 3.5-inch insert holds four screws. 8 Attach the four screws to the diskette drive as shown in Figure 3-7. 54 Installing System Components