Dell PowerEdge T100 Hardware Owner's Manual - Page 97
Replacing the I/O Panel Assembly, up with the alignment stop. See
View all Dell PowerEdge T100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 97 highlights
Figure 3-30. Removing and Installing the I/O Panel Assembly 1 2 3 1 screw on the I/O panel 3 alignment stop on chassis 5 holding tab on the chassis 4 5 2 I/O panel assembly 4 I/O panel securing slot Replacing the I/O Panel Assembly CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. Before you begin this procedure, review the safety instructions that came with the system. 1 Fit the I/O panel assembly so that the holding tab on the front of the chassis catches at its bottom securing slot and the I/O panel assembly lines up with the alignment stop. See Figure 3-30. 2 Secure the I/O panel assembly by replacing the screw. See Figure 3-30. Installing System Components 97