Dell PowerEdge T100 Hardware Owner's Manual - Page 91
the front of the system, then lift it out of the system chassis. See,
View all Dell PowerEdge T100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 91 highlights
6 Remove the I/O panel and SATA cables (if present) attached to the routing clips on the side of the power supply. 7 Using a #2 Phillips screwdriver, remove the four Phillips screws that secure the power supply to the back panel. 8 Press the power-supply release tab down and slide the power supply toward the front of the system, then lift it out of the system chassis. See Figure 3-27. 9 Remove the cable clip and set it aside to attach to the new power supply. Figure 3-27. Removing the Power Supply 1 2 3 1 power supply release tab 3 screws (4) 4 2 power supply 4 cable clip Installing System Components 91
Installing System Components
91
6
Remove the I/O panel and SATA cables (if present) attached to the routing
clips on the side of the power supply.
7
Using a #2 Phillips screwdriver, remove the four Phillips screws that secure
the power supply to the back panel.
8
Press the power-supply release tab down and slide the power supply toward
the front of the system, then lift it out of the system chassis. See
Figure 3-27.
9
Remove the cable clip and set it aside to attach to the new power supply.
Figure 3-27.
Removing the Power Supply
1
power supply release tab
2
power supply
3
screws (4)
4
cable clip
3
1
2
4