HP 6125XLG R2306-HP 6125XLG Blade Switch Layer 3 - IP Services Configuration G - Page 173
Con Switch B
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 173 highlights
cannot be automatically obtained from the destination IPv6 addresses of packets, configure an IPv6 over IPv4 manual tunnel. Figure 73 Network diagram Configuration procedure Make sure Switch A and Switch B have the corresponding VLAN interfaces created and can reach each other through IPv4. • Configure Switch A: # Specify an IPv4 address for VLAN-interface 100. system-view [SwitchA] interface vlan-interface 100 [SwitchA-Vlan-interface100] ip address 192.168.100.1 255.255.255.0 [SwitchA-Vlan-interface100] quit # Specify an IPv6 address for VLAN-interface 101. [SwitchA] interface vlan-interface 101 [SwitchA-Vlan-interface101] ipv6 address 3002::1 64 [SwitchA-Vlan-interface101] quit # Create service loopback group 1 and specify its service type as tunnel. [SwitchA] service-loopback group 1 type tunnel # Add Ten-GigabitEthernet 1/1/5 to service loopback group 1. [SwitchA] interface Ten-GigabitEthernet 1/1/5 [SwitchA-Ten-GigabitEthernet1/1/5] port service-loopback group 1 [SwitchA-Ten-GigabitEthernet1/1/5] quit # Configure an IPv6 over IPv4 manual tunnel interface tunnel 0. [SwitchA] interface tunnel 0 mode ipv6-ipv4 # Specify the source interface for the tunnel interface as VLAN-interface 100. [SwitchA-Tunnel0] source vlan-interface 100 # Specify the destination address for the tunnel interface as the IP address of the VLAN-interface 100 on Switch B. [SwitchA-Tunnel0] destination 192.168.50.1 [SwitchA-Tunnel0] quit # Configure a static route destined for IPv6 network 2 through tunnel 0 on Switch A. [SwitchA] ipv6 route-static 3003:: 64 tunnel 0 • Configure Switch B: # Specify an IPv4 address for VLAN-interface 100. system-view [SwitchB] interface vlan-interface 100 [SwitchB-Vlan-interface100] ip address 192.168.50.1 255.255.255.0 165