HP 6125XLG R2306-HP 6125XLG Blade Switch Layer 3 - IP Services Configuration G - Page 202
Con interface VLAN-interface 101., on Switch B.
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 202 highlights
[SwitchA] interface vlan-interface 101 [SwitchA-Vlan-interface101] ipv6 address 2002::1:1 64 [SwitchA-Vlan-interface101] quit # Create service loopback group 1, and configure the service type as tunnel. [SwitchA] service-loopback group 1 type tunnel # Add port Ten-GigabitEthernet 1/1/5 to service loopback group 1. [SwitchA] interface Ten-GigabitEthernet 1/1/5 [SwitchA-Ten-GigabitEthernet1/1/5] port service-loopback group 1 [SwitchA-Ten-GigabitEthernet1/1/5] quit # Create a tunnel interface Tunnel0, and specify the tunnel mode as GRE over IPv6. [SwitchA] interface tunnel 0 mode gre ipv6 # Configure an IP address for the tunnel interface. [SwitchA-Tunnel0] ip address 10.1.2.1 255.255.255.0 # Configure the source address of the tunnel interface as the IPv6 address of VLAN-interface 101 on Switch A. [SwitchA-Tunnel0] source 2002::1:1 # Configure the destination address of the tunnel interface as the IPv6 address of VLAN-interface 101 on Switch B. [SwitchA-Tunnel0] destination 2001::2:1 [SwitchA-Tunnel0] quit # Configure a static route from Switch A through the tunnel interface to Group 2. [SwitchA] ip route-static 10.1.3.0 255.255.255.0 tunnel 0 2. Configure Switch B: # Configure interface VLAN-interface 100. system-view [SwitchB] vlan 100 [SwitchB-vlan100] port Ten-GigabitEthernet 1/1/7 [SwitchB-vlan100] quit [SwitchB] interface vlan-interface 100 [SwitchB-Vlan-interface100] ip address 10.1.3.1 255.255.255.0 [SwitchB-Vlan-interface100] quit # Configure interface VLAN-interface 101. [SwitchB] vlan 101 [SwitchB-vlan101] port Ten-GigabitEthernet 1/1/6 [SwitchB-vlan101] quit [SwitchB] interface vlan-interface 101 [SwitchB-Vlan-interface101] ipv6 address 2001::2:1 64 [SwitchB-Vlan-interface101] quit # Create service loopback group 1, and configure the service type as tunnel. [SwitchB] service-loopback group 1 type tunnel # Add port Ten-GigabitEthernet 1/1/5 to service loopback group 1. [SwitchB] interface Ten-GigabitEthernet 1/1/5 [SwitchB-Ten-GigabitEthernet1/1/5] port service-loopback group 1 [SwitchB-Ten-GigabitEthernet1/1/5] quit # Create a tunnel interface Tunnel0, and specify the tunnel mode as GRE over IPv6. [SwitchB] interface tunnel 0 mode gre ipv6 194