HP 6125XLG R2306-HP 6125XLG Blade Switch Layer 3 - IP Services Configuration G - Page 179
Network diagram
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 179 highlights
Figure 75 Network diagram Configuration procedure Make sure the corresponding VLAN interfaces have been created on the switch. Make sure VLAN-interface 101 on the ISATAP switch and the ISATAP host can reach each other through IPv4. • Configure the switch: # Specify an IPv6 address for VLAN-interface 100. system-view [Switch] interface vlan-interface 100 [Switch-Vlan-interface100] ipv6 address 3001::1/64 [Switch-Vlan-interface100] quit # Specify an IPv4 address for VLAN-interface 101. [Switch] interface vlan-interface 101 [Switch-Vlan-interface101] ip address 1.1.1.1 255.0.0.0 [Switch-Vlan-interface101] quit # Create service loopback group 1 and specify its service type as tunnel. [Switch] service-loopback group 1 type tunnel # Assign Ten-GigabitEthernet 1/1/5 to service loopback group 1. [Switch] interface Ten-GigabitEthernet 1/1/5 [Switch-Ten-GigabitEthernet1/1/5] port service-loopback group 1 [Switch-Ten-GigabitEthernet1/1/5] quit # Configure an ISATAP tunnel interface tunnel 0. [Switch] interface tunnel 0 mode ipv6-ipv4 isatap # Configure an ISATAP address for the tunnel interface tunnel 0. [Switch-Tunnel0] ipv6 address 2001::5efe:0101:0101 64 # Configure VLAN-interface 101 as the source interface of the tunnel interface. [Switch-Tunnel0] source vlan-interface 101 # Disable RA suppression so that the ISATAP host can acquire information such as the address prefix from the RA message advertised by the ISATAP switch. [Switch-Tunnel0] undo ipv6 nd ra halt [Switch-Tunnel0] quit # Configure a static route to the ISATAP host. [Switch] ipv6 route-static 2001:: 16 tunnel 0 • Configure the ISATAP host: Configurations on the ISATAP host vary depending on the operating system. The following example is performed on Windows XP. 171