HP 6125XLG R2306-HP 6125XLG Blade Switch Layer 3 - IP Services Configuration G - Page 198
GRE configuration examples, GRE over IPv4 configuration example, Network requirements
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 198 highlights
Task Command Remarks Display information about tunnel interfaces. display interface [ tunnel [ number ] ] [ brief ] For more information about this command, see Layer 3-IP Services Command Reference. Display IPv6 information about display ipv6 interface [ tunnel tunnel interface. [ number ] ] [ brief ] For more information about this command, see Layer 3-IP Services Command Reference. GRE configuration examples GRE over IPv4 configuration example Network requirements Switch A and Switch B are connected to the Internet running IPv4. Establish a GRE tunnel between the switches to interconnect the two private IPv4 networks Group 1 and Group 2. Figure 82 Network diagram Switch A XGE1/1/6 Vlan-int101 XGE1/1/5 1.1.1.1/24 XGE1/1/7 Vlan-int100 10.1.1.1/24 Tunnel1 10.1.2.1/24 Internet GRE tunnel XGE1/1/6 Switch B Vlan-int101 2.2.2.2/24 XGE1/1/5 Tunnel1 10.1.2.2/24 XGE1/1/7 Vlan-int100 10.1.3.1/24 IPv4 Group 1 Service loopback port IPv4 Group 2 Configuration procedure Before the configuration, make sure Switch A and Switch B can reach each other. 1. Configure Switch A: # Configure interface VLAN-interface 100. system-view [SwitchA] vlan 100 [SwitchA-vlan100] port Ten-GigabitEthernet 1/1/7 [SwitchA-vlan100] quit [SwitchA] interface vlan-interface 100 [SwitchA-Vlan-interface100] ip address 10.1.1.1 255.255.255.0 [SwitchA-Vlan-interface100] quit # Configure interface VLAN-interface 101. [SwitchA] vlan 101 [SwitchA-vlan101] port Ten-GigabitEthernet 1/1/6 [SwitchA-vlan101] quit [SwitchA] interface vlan-interface 101 [SwitchA-Vlan-interface101] ip address 1.1.1.1 255.255.255.0 [SwitchA-Vlan-interface101] quit 190