HP 6125XLG R2306-HP 6125XLG Blade Switch Layer 3 - IP Services Configuration G - Page 186
Create an IPv6 tunnel interface
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 186 highlights
# Specify an IPv4 address for the tunnel interface. [SwitchA-Tunnel1] ip address 30.1.2.1 255.255.255.0 # Specify the IP address of VLAN-interface 101 as the source address for the tunnel interface. [SwitchA-Tunnel1] source 2001::1:1 # Specify the IP address of VLAN-interface 101 on Switch B as the destination address for the tunnel interface. [SwitchA-Tunnel1] destination 2002::2:1 [SwitchA-Tunnel1] quit # Configure a static route destined for IPv4 network 2 through the tunnel interface. [SwitchA] ip route-static 30.1.3.0 255.255.255.0 tunnel 1 • Configure Switch B: # Specify an IPv4 address for VLAN-interface 100. system-view [SwitchB] interface vlan-interface 100 [SwitchB-Vlan-interface100] ip address 30.1.3.1 255.255.255.0 [SwitchB-Vlan-interface100] quit # Specify an IPv6 address for VLAN-interface 101, which is the physical interface of the tunnel. [SwitchB] interface vlan-interface 101 [SwitchB-Vlan-interface101] ipv6 address 2002::2:1 64 [SwitchB-Vlan-interface101] quit # Create service loopback group 1 and specify its service type as tunnel. [SwitchB] service-loopback group 1 type tunnel # Assign Ten-GigabitEthernet 1/1/5 to service loopback group 1. [SwitchB] interface Ten-GigabitEthernet 1/1/5 [SwitchB-Ten-GigabitEthernet1/1/5] port service-loopback group 1 [SwitchB-Ten-GigabitEthernet1/1/5] quit # Create an IPv6 tunnel interface tunnel 2. [SwitchB] interface tunnel 2 mode ipv6 # Specify an IPv4 address for the tunnel interface. [SwitchB-Tunnel2] ip address 30.1.2.2 255.255.255.0 # Specify the IP address of VLAN-interface 101 as the source address for the tunnel interface. [SwitchB-Tunnel2] source 2002::2:1 # Specify the IP address of VLAN-interface 101 on Switch A as the destination address for the tunnel interface. [SwitchB-Tunnel2] destination 2001::1:1 [SwitchB-Tunnel2] quit # Configure a static route destined for IPv4 network 1 through the tunnel interface. [SwitchB] ip route-static 30.1.1.0 255.255.255.0 tunnel 2 Verifying the configuration # Use the display interface tunnel command to display the status of the tunnel interfaces on Switch A and Switch B. The output shows that the tunnel interfaces are up. (Details not shown.) # Ping the IPv4 address of the peer interface from each switch. The following shows the output on Switch A. [SwitchA] ping -a 30.1.1.1 30.1.3.1 178