HP 6125XLG R2306-HP 6125XLG Blade Switch Layer 3 - IP Services Configuration G - Page 49
Enabling DHCP, Enabling the DHCP server on an interface
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
Step 2. Enter DHCP address pool view. 3. Configure a self-defined DHCP option. Command dhcp server ip-pool pool-name option code { ascii ascii-string | hex hex-string | ip-address ip-address& } Remarks N/A By default, no self-defined DHCP option is configured. Table 2 Common DHCP options Option 3 6 15 44 46 66 67 43 Option name Router Option Domain Name Server Option Domain Name NetBIOS over TCP/IP Name Server Option NetBIOS over TCP/IP Node Type Option TFTP server name Boot file name Vendor Specific Information Corresponding command gateway-list dns-list domain-name nbns-list netbios-type tftp-server bootfile-name N/A Recommended option command parameters ip-address ip-address ascii ip-address hex ascii ascii hex Enabling DHCP You must enable DHCP to validate other DHCP configurations. To enable DHCP: Step 1. Enter system view. 2. Enable DHCP. Command system-view dhcp enable Remarks N/A By default, DHCP is disabled. Enabling the DHCP server on an interface Perform this task to enable the DHCP server on an interface. Upon receiving a DHCP request on the interface, the DHCP server assigns an IP address and other configuration parameters from the DHCP address pool to the DHCP client. To enable the DHCP server on an interface: Step 1. Enter system view. 2. Enter interface view. Command system-view interface interface-type interface-number Remarks N/A N/A 40