HP 6125XLG R2306-HP 6125XLG Blade Switch Layer 3 - IP Services Configuration G - Page 183
Specify the IP address of VLAN-interface 101 on Switch A as the destination address for
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 183 highlights
# Create an IPv4 over IPv4 tunnel interface tunnel 1. [SwitchA] interface tunnel 1 mode ipv4-ipv4 # Specify an IPv4 address for the tunnel interface. [SwitchA-Tunnel1] ip address 10.1.2.1 255.255.255.0 # Specify the IP address of VLAN-interface 101 as the source address for the tunnel interface. [SwitchA-Tunnel1] source 2.1.1.1 # Specify the IP address of VLAN-interface 101 on Switch B as the destination address for the tunnel interface. [SwitchA-Tunnel1] destination 3.1.1.1 [SwitchA-Tunnel1] quit # Configure a static route destined for the IP network Group 2 through the tunnel interface. [SwitchA] ip route-static 10.1.3.0 255.255.255.0 tunnel 1 • Configure Switch B: # Specify an IPv4 address for VLAN-interface 100. system-view [SwitchB] interface vlan-interface 100 [SwitchB-Vlan-interface100] ip address 10.1.3.1 255.255.255.0 [SwitchB-Vlan-interface100] quit # Specify an IPv4 address for VLAN-interface 101, which is the physical interface of the tunnel. [SwitchB] interface vlan-interface 101 [SwitchB-Vlan-interface101] ip address 3.1.1.1 255.255.255.0 [SwitchB-Vlan-interface101] quit # Create service loopback group 1 and specify its service type as tunnel. [SwitchB] service-loopback group 1 type tunnel # Assign Ten-GigabitEthernet 1/1/5 to service loopback group 1. [SwitchB] interface Ten-GigabitEthernet 1/1/5 [SwitchB-Ten-GigabitEthernet1/1/5] port service-loopback group 1 [SwitchB-Ten-GigabitEthernet1/1/5] quit # Create an IPv4 over IPv4 tunnel interface tunnel 2. [SwitchB] interface tunnel 2 mode ipv4-ipv4 # Specify an IPv4 address for the tunnel interface. [SwitchB-Tunnel2] ip address 10.1.2.2 255.255.255.0 # Specify the IP address of VLAN-interface 101 as the source address for the tunnel interface. [SwitchB-Tunnel2] source 3.1.1.1 # Specify the IP address of VLAN-interface 101 on Switch A as the destination address for the tunnel interface. [SwitchB-Tunnel2] destination 2.1.1.1 [SwitchB-Tunnel2] quit # Configure a static route destined for the IP network Group 1 through the tunnel interface. [SwitchB] ip route-static 10.1.1.0 255.255.255.0 tunnel 2 Verifying the configuration # Use the display interface tunnel command to display the status of the tunnel interfaces on Switch A and Switch B. The output shows that the tunnel interfaces are up. (Details not shown.) 175