HP 6125XLG R2306-HP 6125XLG Blade Switch Layer 3 - IP Services Configuration G - Page 189
Specify an IPv6 address for VLAN-interface 100., which is the physical interface of the tunnel.
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 189 highlights
# Assign Ten-GigabitEthernet 1/1/5 to service loopback group 1. [SwitchA] interface Ten-GigabitEthernet 1/1/5 [SwitchA-Ten-GigabitEthernet1/1/5] port service-loopback group 1 [SwitchA-Ten-GigabitEthernet1/1/5] quit # Create an IPv6 tunnel interface tunnel 1. [SwitchA] interface tunnel 1 mode ipv6 # Specify an IPv6 address for the tunnel interface. [SwitchA-Tunnel1] ipv6 address 3001::1:1 64 # Specify the IP address of VLAN-interface 101 as the source address for the tunnel interface. [SwitchA-Tunnel1] source 2001::11:1 # Specify the IP address of VLAN-interface 101 on Switch B as the destination address for the tunnel interface. [SwitchA-Tunnel1] destination 2002::22:1 [SwitchA-Tunnel1] quit # Configure a static route destined for the IPv6 network Group 2 through the tunnel interface. [SwitchA] ipv6 route-static 2002:3:: 64 tunnel 1 • Configure Switch B: # Specify an IPv6 address for VLAN-interface 100. system-view [SwitchB] interface vlan-interface 100 [SwitchB-Vlan-interface100] ipv6 address 2002:3::1 64 [SwitchB-Vlan-interface100] quit # Specify an IPv6 address for VLAN-interface 101, which is the physical interface of the tunnel. [SwitchB] interface vlan-interface 101 [SwitchB-Vlan-interface101] ipv6 address 2002::22:1 64 [SwitchB-Vlan-interface101] quit # Create service loopback group 1 and specify its service type as tunnel. [SwitchB] service-loopback group 1 type tunnel # Assign Ten-GigabitEthernet 1/1/5 to service loopback group 1. [SwitchB] interface Ten-GigabitEthernet 1/1/5 [SwitchB-Ten-GigabitEthernet1/1/5] port service-loopback group 1 [SwitchB-Ten-GigabitEthernet1/1/5] quit # Create an IPv6 tunnel interface tunnel 2. [SwitchB] interface tunnel 2 mode ipv6 # Specify an IPv6 address for the tunnel interface. [SwitchB-Tunnel2] ipv6 address 3001::1:2 64 # Specify the IP address of VLAN-interface 101 as the source address for the tunnel interface. [SwitchB-Tunnel2] source 2002::22:1 # Specify the IP address of VLAN-interface 101 on Switch A as the destination address for the tunnel interface. [SwitchB-Tunnel2] destination 2001::11:1 [SwitchB-Tunnel2] quit # Configure a static route destined to the IPv6 network Group 1 through the tunnel interface. [SwitchB] ipv6 route-static 2002:1:: 64 tunnel 2 181