HP 9085mfp HP 9085mfp - (English) System Administrator Guide - Page 149

Programmed Shut-Off (Weekly Timer) (continued) The Timer Interrupt password is not factory set and must be entered by the Key Operator. In the event the Timer Interrupt password has not been entered by the Key Operator, the following message will display instead. Input copy time 0 hour(s) 05 minute(s) When the above message displays, proceed to step 4. 2. Enter the password. Enter a 4-digit number Timer Interrupt password using the keypad on the control panel. HINT For setting the Timer Interrupt password, see p. 13-35. DETAILS If an invalid password is entered, continue by entering the valid 4-digit password. 3. Press [START]. The following message will be displayed on the Basic Screen. Input copy time 0 hour(s) 05 minute(s) 4. Set the hour for the interrupt use. Enter a 1-digit hour (ex. 3 hours is 3) using the keypad on the control panel. (0 ~ 9) 5. Press [START]. 6. Set the minute for the interrupt use. Enter a 2-digit minute (ex. 7 minutes is 07) using the keypad on the control panel. (00 ~ 59) Weekly Timer Rotation Vertical/Horizontal Zoom Fold / Stitch&Fold Punch Z-Fold Trimming Cover Sheet Feeding Using Finisher Manually Tandem Mode 7 Advanced Information DETAILS Entering a number smaller than 5 will set the minute at 5. 7. Press [START]. Copying is available until the set time is up. 8. When Timer Interrupt of the mfp is finished, press [SLEEP ON/OFF] for one second or longer, then release it. The mfp returns to the OFF condition and copying is again disabled. 7-3