HP 9085mfp HP 9085mfp - (English) System Administrator Guide - Page 58
Loading Tabbed Sheets in Tray 1, 2, or 3
View all HP 9085mfp manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
Loading Paper (continued) Loading Tabbed Sheets in Tray 1, 2, or 3 When TAB is displayed on the tray key of the Basic Screen, follow the procedure below to supply the tray with tabbed sheets. HINT The tray paper type can be specified in the Key Operator setting. For details, see p. 13-23 to p. 13-24. Rear Rear Example: 3 Tabbed sheets loaded in position for one finished set. Front Section 3 Management Printed side 1st TAB Section 1 Introduction 2nd TAB 1st TAB 2nd TAB 3rd TAB 3rd TAB ONE FINISHED SET Example: 9 Tabbed sheets loaded in position for 3 finished sets. Front Section 3 SMecatnioang3ement SMeacntiaogne3ment Management 1st TAB 2nd TAB Section 1 Introduction Section 1 Introduction Section 1 Introduction 1st TABS 2nd TABS 3rd TABS Printed side 3rd TAB 3 FINISHED SETS Reminder! The tab extension width should be 12.5mm or less. 1. Withdraw tray 1, 2, or 3. 2. Open the paper feed roller. 3. Place the tabbed sheets on the tray as illustrated above. 4. Move the green levers (located at the front and the left side) to the edge of the paper. 5. Close the paper feed roller, then push in the tray until it locks into place. 2-28