HP 9085mfp HP 9085mfp - (English) System Administrator Guide - Page 93

Copying Using Memory (continued) 4. Position original(s). Using platen glass: Place original FACE DOWN. Start scanning from the first page. Reminder! When Dual Page, Non-Image Area Erase, Auto detection mode of Repeat, or AUTO Layout is selected, keep the RADF open throughout the scanning procedure. Using RADF: Position originals FACE UP. If the number of originals exceeds 100, divide them into blocks not exceeding 100 sheets and load them from the block with the first page. HINT See p. 3-2 to p. 3-6 for details on positioning originals. 5. Press [START] to scan. 3 Copying Operations Positioning Originals Setting Print Quantity Set Job During Warmup Stop Scan/Print Paper Size DETAILS Repeat steps 4 and 5 until all originals are scanned. Memory indicator on the upper right of the Basic Screen allows you to check the remaining memory. To delete the scanned data without printing, press [STOP], then touch EXIT on the confirmation screen to be sure the data is deleted. HINT Should memory overflow occur frequently, it is recommended that you contact your service representative to extend the memory capacity in your machine. 6. Touch STORE to exit the Store mode. STORE will return to the normal display. 7. Press [START]. All the data in memory will be output. Press [STOP] to suspend the printing job. CAUTION When the finisher / trimmer unit / paper exit tray capacity is exceeded due to the print quantity selected, remove the copied sets as they exit; otherwise, mishandled paper will occur. Lens Mode Density 1-2, 2-2 2-1 Multi-Sheet Bypass Tray Using Memory Output without Finisher Q3219A/Q3220A Output Modes Binding Mode Recalling Previous Job Check Mode & Proof Copy Interrupt Mode 3-33