HP 9085mfp HP 9085mfp - (English) System Administrator Guide - Page 73

Selecting Paper Size (continued) To Specify Desired Paper Size (AMS) When a paper size is specified on the touch screen, an appropriate reduction or enlargement ratio will be selected automatically according to the original size detected from the RADF or the platen glass. HINTS • See the table on the following page for the relation of original size, copy paper size, and magnification ratio automatically selected. • Wide paper size can be specified when AMS is in use. In this case, the same magnification ratio as that of the standard size will be selected automatically. • If copying in 1.00 (100%) magnification mode and specifying a paper size, see p. 3-15. 1. Touch a tray key on the Basic Screen to select the desired paper size. 3 Copying Operations Positioning Originals Setting Print Quantity Set Job During Warmup Stop Scan/Print Paper Size Lens Mode Density 1-2, 2-2 Selected tray key will be highlighted, and under the LENS MODE AMS indication will also be highlighted. 2. Select additional copy conditions, as desired. 3. Enter the desired print quantity from the control panel keypad. HINT See p. 3-7 for details on setting print quantity. 4. Position original(s). HINTS • See p. 11-8 to p. 11-10 for paper sizes detectable from the RADF or on the platen glass. • See p. 3-2 to p. 3-6 for details on positioning originals. 5. Press [START]. Scanned image will be printed on the specified paper size using an automatically selected magnification ratio. 2-1 Multi-Sheet Bypass Tray Using Memory Output without Finisher Q3219A/Q3220A Output Modes Binding Mode Recalling Previous Job Check Mode & Proof Copy Interrupt Mode DETAILS Copy result may not be satisfactory due to the Rotation function. In this case, turn the function OFF manually. See. p. 7-4. 3-13