HP 9085mfp HP 9085mfp - (English) System Administrator Guide - Page 71

Selecting Paper Size To select an appropriate paper size for getting your desired copy result, use APS (Automatic Paper Selection), or select paper size manually on the touch screen, as required. To Select Paper Size Automatically (APS) APS detects the size of originals placed on the RADF or platen glass and automatically selects and feeds copy paper of the same size, or selects an appropriate size according to the magnification ratio selected. HINTS • See the table on the following page for the relation of original size, magnification ratio and copy paper size. • The initial settings may have been altered by Key Operator. See p. 13-10 to p. 13-11. 1. Touch to highlight APS at lower right corner of the Basic Screen. 3 Copying Operations Positioning Originals Setting Print Quantity Set Job During Warmup Stop Scan/Print Paper Size Lens Mode Density 1-2, 2-2 2-1 APS is already highlighted when the initial settings are restored. 2. Select additional copy conditions, as desired. 3. Enter the desired print quantity from the control panel keypad. HINT See p. 3-7 for details on setting print quantity. 4. Position original(s). HINTS • See p. 11-8 to p. 11-10 for paper sizes detectable from the RADF or on the platen glass. • See p. 3-2 to p. 3-6 for details on positioning originals. • Key Operator can deactivate APS when original is set in the RADF or on the platen glass. See p. 13-39 to p. 13-44. 5. Press [START]. Scanned image will be printed on the paper size automatically selected. Multi-Sheet Bypass Tray Using Memory Output without Finisher Q3219A/Q3220A Output Modes Binding Mode Recalling Previous Job Check Mode & Proof Copy Interrupt Mode DETAILS • If the appropriate copy paper is not loaded in any tray, no copying will be performed, and a message will prompt you to load the appropriate paper. • Copy result may not be satisfactory due to the Rotation function. In this case, turn the function OFF manually. See. p. 7-4. 3-11