HP 9120 HP Officejet 9100 - User Guide - Page 188
Open the print-carriage access door and check inside the all-in-one for any remaining
UPC - 829160117782
View all HP 9120 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 188 highlights
e If you cannot locate the jam, go to the next step. 4 Lift the output tray and check for a jam in tray 1. a If the media is jammed in tray 1, pull out tray 1. (Otherwise, go to step 5.) b Pull the paper towards you as shown in the following illustration. c Lower the output tray and reposition tray 1. 5 If you have not yet found the jam, check tray 2 (if it is available). (Otherwise, go to the next step.) a Pull out tray 2. If you see the jammed media, remove it from tray 2. b If you cannot locate the jammed media by removing tray 2 from the all-in-one, turn off the all-in-one (if you have not already done so), and then remove the power cord. c Lift the all-in-one off of tray 2. d Remove the jammed media from the bottom of the all-in-one or from tray 2. e Reposition the all-in-one on top of tray 2. 6 Open the print-carriage access door and check inside the all-in-one for any remaining media. If media remains inside the all-in-one, use the following steps below. (Otherwise, go to step 7.) WARNING! a When you lift the print-carriage access door, the carriage should return to the right side of the all-in-one. If the carriage does not return to the right side, turn off the all-in-one. Do not reach into the all-in-one when the all-in-one is on and the carriage is stuck. b Free the media and pull it towards you through the top of the all-in-one. 7 After you clear the jam, close all of the covers and turn on the all-in-one. You will need to resubmit the job. 186 10 - Maintaining and troubleshooting ENWW