HP Integrity Superdome 2 HP Integrity Superdome 2 Onboard Administrator User G - Page 83
Interconnect Module Information screen., Virtual Power
View all HP Integrity Superdome 2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
4. While the First Time Setup Wizard is running (alternately, after first time setup you can change the EBIPA settings in the Enclosure Settings list), enable Device Bay EBIPA with a starting static IP address and enable Interconnect Bay EBIPA with a different starting IP address. The Onboard Administrator then creates 16 sequential IP addresses for the device bays and 8 sequential IP addresses for the interconnect bays. Servers in the device bays will automatically get the Device Bay EBIPA addresses within a minute, but the interconnect switch modules must to be manually restarted by clicking the Virtual Power button on each Onboard Administrator Interconnect Module Information screen. 5. Use the Onboard Administrator Device list to be sure that the server blade iLO addresses have been set according to the EBIPA starting IP address and range. When a server blade or interconnect module is inserted into a device bay that has EBIPA enabled, the management port gets the specific static IP address from the Onboard Administrator if the device is configured for DHCP. If the device is configured for static IP, it must be manually reconfigured to DHCP to change to the EBIPA IP address. The administrator sets an independent range for device bays and interconnect module bays using the Onboard Administrator EBIPA setup wizard. The first address in a range is assigned to the first bay and then consecutive bays through the range. For example, if you set the server bay EBIPA range starting from 16.100.226.21 to 16.100.226.36, the iLO 3 in Server bay #1 will be assigned 16.100.226.21 and the iLO 3 in Server bay #12 is assigned 16.100.226.32, and the interconnect bay EBIPA range to 16.200.139.51 to 16.200.139.58. If you set the interconnect module port, the interconnect bay #1 is set to 16.200.139.51 and the interconnect module management port in Interconnect bay #7 is set to 16.200.139.57. Knowing your network configuration before setting up EBIPA ensures an easy setup and enables you to install your HP Superdome 2 Onboard Administrator on to your network quickly. Record Enclosure settings 83