HP LH4r HP NetRAID-4M Installation Guide - Page 10
Controller Management Utilities, Flexible Array Storage Tool FAST
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Hewlett-Packard NetRAID-4M Controller Installation Guide For more information, see Chapter 2, Installing the Hardware. 2 Optionally create and configure containers using the HP NetRAID-4M BIOS. For more information, see Appendix B, Using the BIOS Container Configuration Utility. 3 Install the HP NetRAID-4M device drivers. For more information, see Chapter 4, Installing the Device Drivers. 4 Install the RAID Controller Management Software. For more information, see Chapter 5, Installing the Controller Management Software. 5 Install the clustering software to support Microsoft clusters. For information on performing a cluster installation, see Chapter 7, Installing Clusters. Note: This version of the HP NetRAID-4M controller software and firmware is incompatible with earlier versions. If you have an existing controller in your system that has an earlier version of the firmware and software installed and are adding a new controller, you must upgrade the older controller's firmware, drivers, and Controller Management Software to this release (and they must be upgraded as a complete set). For information on how to perform the upgrade, see Chapter 3, Performing an Upgrade Installation. Controller Management Utilities The HP NetRAID-4M supports the following management utilities: s Flexible Array Storage Tool (FAST)- FAST software enables you to manage data, files, and storage devices in an easy-touse graphical interface with wizard support. In addition, you can integrate the FAST software with higher-level management platforms to unify systems and network management. FAST can create a container (logical drive) consisting of partitions on different disks, where each partition is less than the entire disk's capacity. FAST can be used to 1-2