HP LH4r HP NetRAID-4M Installation Guide - Page 112
Communications, Use_IP, IP_PORT, IPX_SOCKET, Client_timeout
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 112 highlights
Hewlett-Packard NetRAID-4M Controller Installation Guide Communications The communications section provides switches that control how communication will be configured. The communication section will contain the following switches: s Use_IP - if this switch is set to TRUE then the HP NetRAID4M Remote Agent will attempt to use IP as a communications protocol. s IP_PORT - this switch will specify, in decimal, the IP port that will be used for communications. This may be helpful to users that are trying to access the controller through a firewall. The IP_PORT is specified as a four-octet address, for example, 128.10.2.30. s Use_IPX - if this switch is set to TRUE then the HP NetRAID4M Remote Agent will attempt to use IPX as a communications protocol. s IPX_SOCKET - this switch will specify, in decimal, the IPX socket that will be used for communications. This may be helpful to users that are trying to access the controller through a firewall. The IPX_SOCKET is specified as a hexadecimal address, for example, 4640E44D.000000000001. s Client_timeout - this switch specifies, in seconds, the amount of time that the software will allow to expire before closing communications with the client. ❒ C-6