HP LH4r HP NetRAID-4M Installation Guide - Page 53
Openserver, hpnraid, SCO OpenServer 5.0.x Boot NetRAID-4M, OpenServer 5.0.x Boot NetRAID-4M
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
Installing the Device Drivers s Openserver ! Caution: Before installing the Openserver device drivers for your HP NetRAID-4M container, ensure that you have placed the HP NetRAID-4M controller in the correct PCI slot; otherwise the driver will not install. For information on supported PCI slots, see the HP NetRAID-4M Installation Supplement. a At the initial boot prompt, enter the word link. b When prompted for the name of additional drivers, enter the word hpnraid. c When prompted, insert the diskette you created that contains the SCO OpenServer 5.0.x Boot NetRAID-4M driver into your system's diskette drive. d Complete the Openserver installation. e When the Openserver installation completes, remove the driver diskette from the diskette drive and reboot the system. f Log onto the system as root and place the SCO OpenServer 5.0.x Boot NetRAID-4M driver diskette in the diskette drive. g Mount the SCO OpenServer 5.0.x Boot NetRAID-4M driver diskette by entering the following command, replacing DISKETTE_LUN with the logical unit number that corresponds to the diskette drive (in most cases, this will be /dev/fd0): mount -f S51K /dev/DISKETTE_LUN /mnt h Run the driver configuration program by entering the following commands: cd /mnt/install 4-19