HP LH4r HP NetRAID-4M Installation Guide - Page 76
Enabling Clustering in the BIOS and Setting the SCSI IDs, Installing, the Controller Card
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
Hewlett-Packard NetRAID-4M Controller Installation Guide 3 Cable the controllers across a shared SCSI channel to the shared clustered storage devices. For instructions, see Installing the Controller Card on page 2-3 and on page 2-6. Make sure that the controllers are SCSI terminated for the shared channel. 4 Install one of the following operating systems on each cluster node (all nodes must run the same operating system): - Windows NT Enterprise Server V4.0 with Service Pack 3 (or higher) - Windows 2000 with the most recent service pack During installation of the operating system, install the controller device drivers appropriate for that operating system. For information about installing the device drivers, see Chapter 4, Installing the Device Drivers. Note: Service Pack 3, which is the minimal service pack required to run Microsoft Cluster Service (MSCS) software, is integrated with Windows NT Enterprise Server V4.0. For convenience, you can install Service Pack 3 when you install Windows NT and upgrade to Service Pack 6A (which is recommended) following the installation of the Microsoft Cluster Service software. 5 On each cluster node, install the Controller Management Software. For information about installing the Controller Management Software, see Chapter 5, Installing the Controller Management Software. Enabling Clustering in the BIOS and Setting the SCSI IDs To enable clustering support and set the SCSI IDs for the HP NetRAID-4M controllers installed in your cluster nodes, follow these steps on all nodes in the cluster: 1 Reboot your system, so that you can access the Container Configuration Utility (CCU) in the controller's BIOS. 7-2