HP LH4r HP NetRAID-4M Installation Guide - Page 54
drive_config, dev/rdsk, c0t0d0, idbuild
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
Hewlett-Packard NetRAID-4M Controller Installation Guide ./drive_config Note: Owing to a software limitation, OpenServer's method of statically configuring each disk into the kernel can cause user confusion. The difficulty arises from OpenServer's convention for naming drives. The drive_config utility overcomes this limitation by automatically creating the appropriate kernel entries and then rebuilding/relinking the kernel. The drive_config utility automatically creates device special files in the /dev/rdsk and /dev/dsk directories. These files are named in the c#t#d#s# (controller number, target number, disk number, fdisk partition number) format. On a boot container, the files c0t0d0 and c0t0d0s0 point to the entire disk. For more information on OpenServer disk partitioning conventions, see the appropriate OpenServer documentation. i Answer yes to all prompts from the idbuild utility. j When the driver configuration completes, reboot your system so that the operating system will recognize the driver. 4-20