HP LH4r HP NetRAID-4M Installation Guide - Page 69
UnixWare, hpnapps, Linux, The operating system may automount the cdrom
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
Installing the Controller Management Software system hpnapps Hewlett-Packard Raid Applications c If the application software already exists on your system, remove it by entering the following command: pkgrm hpnapps d You will be prompted to confirm the deletion; answer yes to the prompt. s UnixWare a To determine if the hpnapps kit is installed on your UnixWare system, enter the following command: pkginfo hpnapps b If the application software exists on your UnixWare system, the pkginfo command will return a message like the following: system hpnapps Hewlett-Packard Raid Applications c If the application software already exists on your system, remove it by entering the following command: pkgrm hpnapps d You will be prompted to confirm the deletion; answer yes to the prompt. 3 Install the application software. s Linux a Place the Navigator cdrom which contains the UNIX Controller Management Software in the cdrom drive. The operating system may automount the cdrom on /mnt/cdrom. If not, do the following: i Create the mount point by entering the following command: mkdir /mnt/cdrom ii Mount the cdrom on /mnt/cdrom by entering a command like the following, replacing CDROM_LUN with the logical unit number of your cdrom device (note that in most cases the default cdrom lun is cdrom): mount -t iso9660 /dev/CDROM_LUN /mnt/cdrom 5-7