Netgear XSM4348CS CLI Manual Software Version 12.x - Page 1012
set ip mroute static-multicast, no ip mroute
![]() |
View all Netgear XSM4348CS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1012 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches no ip mroute This command removes the configured IPv4 multicast static route. Format Mode no ip mroute src-ip-addr Global Config set ip mroute static-multicast This command configures a static multicast route for a multicast group IP address and a list of VLANs that are enabled for routing. Default Format Mode No default static routes set ip mroute static-multicast group-ip-address vlan-list Global Config Parameters group-ip-address vlan-list Description A multicast group IP address. A list of VLANs in the range of 1 to 4093. Each VLAN ID must be separated by a comma. Note the following requirements: • All VLANs that you specify in the list must be enabled for routing with an IP address configured. • You cannot configure two static multicast routes with the same group IP address, even though the VLAN lists differ. If you must change the VLAN list for a static route, delete the existing static route and create a new one with an updated VLAN list. Command example: To install a static route for multicast group address 224.0.1.129 for VLANs 1, 2, 3, and 4, enter the following command: (config)#ip mroute static-multicast 224.0.1.129 1,2,3,4 no ip mroute static-multicast This command removes a static multicast route for a group IP address. The group-ip-address argument represents the multicast group IP address. Format Mode no set ip mroute static-multicast group-ip-address Global Config IP Multicast Commands 1012 CLI Command Reference Manual
![](/manual_guide/products/netgear-m43008x8f-cli-manual-software-version-12x-6ae8ad6/1012.png)