Netgear XSM4348CS CLI Manual Software Version 12.x - Page 539
ip dhcp snooping binding, ip verify binding, no ip dhcp snooping database write-delay
![]() |
View all Netgear XSM4348CS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 539 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches no ip dhcp snooping database write-delay Use this command to set the write delay value to the default value. Format Mode no ip dhcp snooping database write-delay Global Config ip dhcp snooping binding Use this command to configure static DHCP Snooping binding. Format Mode ip dhcp snooping binding mac-address vlan vlan-id ipaddress interface interface-id Global Config no ip dhcp snooping binding Use this command to remove the DHCP static entry from the DHCP Snooping database. Format Mode no ip dhcp snooping binding mac-address Global Config ip verify binding Use this command to configure static IP source guard (IPSG) entries. Format Mode ip verify binding mac-address vlan vlan-id ipaddress interface interface-id Global Config no ip verify binding Use this command to remove the IPSG static entry from the IPSG database. Format Mode no ip verify binding mac-address vlan vlan-id ipaddress interface interface-id Global Config ip dhcp snooping limit Use this command to control the rate at which the DHCP Snooping messages come on an interface or range of interfaces. By default, rate limiting is disabled. When enabled, the rate can range from 0 to 300 packets per second (pps). The burst level range is 1 to 15 seconds. Switching Commands 539 CLI Command Reference Manual
![](/manual_guide/products/netgear-m43008x8f-cli-manual-software-version-12x-6ae8ad6/539.png)