Netgear XSM4348CS CLI Manual Software Version 12.x - Page 567
set igmp mrouter interface, set igmp flood-report, set igmp exclude-mrouter-intf, no set igmp mrouter
![]() |
View all Netgear XSM4348CS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 567 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches no set igmp mrouter This command disables multicast router mode for a particular VLAN ID. Format Mode no set igmp mrouter vlan-id Interface Config set igmp mrouter interface This command configures the interface or range of interfaces as a multicast router interface. When configured as a multicast router interface, the interface is treated as a multicast router interface in all VLANs. Default Format Mode disabled set igmp mrouter interface Interface Config no set igmp mrouter interface This command disables the status of the interface as a statically configured multicast router interface. Format Mode no set igmp mrouter interface Interface Config set igmp flood-report This command lets the switch forward IGMP Join/Leave PDUs to all other ports in a VLAN. These are IGMP Join/Leave PDUs that the switch receives from a host that is connected to a downstream port. Default Format Mode Enabled for VLAN 1. Disabled for all other VLANs. set igmp flood report [vlan-id] Global Config VLAN Config set igmp exclude-mrouter-intf This command lets the switch forward IGMP Join/Leave PDUs to an upstream mrouter interface. These are IGMP Join/Leave PDUs that the switch receives from a host that is connected to a downstream port. In addition, the switch forwards a multicast data stream to an upstream mrouter interface only if that port already received an IGMPv1 or IGMPv2 membership message. This behavior does not apply to IGMPv3 membership. Switching Commands 567 CLI Command Reference Manual
![](/manual_guide/products/netgear-m43008x8f-cli-manual-software-version-12x-6ae8ad6/567.png)