Netgear XSM4348CS CLI Manual Software Version 12.x - Page 981

M4300 Intelligent Edge Series Fully Managed Stackable Switches IPv6 Access Control List Commands This section describes the commands you use to configure IPv6 Access Control List (ACL) settings. IPv6 ACLs ensure that only authorized users have access to specific resources and block any unwarranted attempts to reach network resources. The following rules apply to IPv6 ACLs: • The maximum number of ACLs you create is 100, regardless of type. • The system supports only Ethernet II frame types. • The maximum number of rules per IPv6 ACL is hardware dependent. ipv6 access-list This command creates an IPv6 Access Control List (ACL) identified by name, consisting of classification fields defined for the IP header of an IPv6 frame. The name parameter is a case-sensitive alphanumeric string from 1 to 31 characters uniquely identifying the IPv6 access list. The rate-limit attribute configures the committed rate and the committed burst size. If an IPv6 ACL by this name already exists, this command enters IPv6-Access-List config mode to allow updating the existing IPv6 ACL. Note: The CLI mode changes to IPv6-Access-List Config mode when you successfully execute this command. Format Mode ipv6 access-list name Global Config no ipv6 access-list This command deletes the IPv6 ACL identified by name from the system. Format Mode no ipv6 access-list name Global Config ipv6 access-list rename This command changes the name of an IPv6 ACL. The name parameter is the name of an existing IPv6 ACL. The newname parameter is a case-sensitive alphanumeric string from 1 to 31 characters uniquely identifying the IPv6 access list. This command fails is an IPv6 ACL by the name that is specified by the newname argument already exists. Quality of Service Commands 981 CLI Command Reference Manual