Netgear XSM4348CS CLI Manual Software Version 12.x - Page 861

M4300 Intelligent Edge Series Fully Managed Stackable Switches Parameter area-id prefix netmask summarylink nssaexternallink advertise not-advertise cost Description The area identifier for the area whose networks are to be summarized. The summary prefix to be advertised when the ABR computes a route to one or more networks within this prefix in this area. When this keyword is given, the area range is used when summarizing prefixes advertised in type 3 summary LSAs. When this keyword is given, the area range is used when translating type 7 LSAs to type 5 LSAs. [Optional] When this keyword is given, the summary prefix is advertised when the area range is active. This is the default. [Optional] When this keyword is given, neither the summary prefix nor the contained prefixes are advertised when the area range is active. When the not-advertise option is given, any static cost previously configured is removed from the system configuration. [Optional] If an optional cost is given, OSPF sets the metric field in the inter-area -prefix LSA to the configured value rather than setting the metric to the largest cost among the networks covered by the area range. no area range The no area range command deletes a summary prefix or removes a static cost. Format Mode no area area-id range prefix netmask {summarylink | nssaexternallink} cost Router OSPFv3 Config area stub (OSPFv3) This command creates a stub area for the specified area ID. A stub area is characterized by the fact that AS External LSAs are not propagated into the area. Removing AS External LSAs and Summary LSAs can significantly reduce the link state database of routers within the stub area. Format Mode area area-id stub Router OSPFv3 Config no area stub This command deletes a stub area for the specified area ID. Format Mode no area area-id stub Router OSPFv3 Config IPv6 Commands 861 CLI Command Reference Manual