Netgear XSM4348CS CLI Manual Software Version 12.x - Page 190

M4300 Intelligent Edge Series Fully Managed Stackable Switches show "command" | section "string" "string2" The command show command (that is, you must enter a keyword of an existing show command for the command parameter) is executed and the output is filtered to only show lines included within the section(s) identified by lines containing the string match and ending with the first line containing the string2 match. If multiple sessions matching the specified string match criteria are part of the base output, then all instances are displayed. show "command" | section "string" include "string2" The command show command (that is, you must enter a keyword of an existing show command for the command parameter) is executed and the output is filtered to only show lines included within the section(s) identified by lines containing the string match and ending with the first line containing the default end-of-section identifier (that is, exit) and that include the string2 match. This type of filter command could also include "exclude" or user-defined end-of-section identifier parameters as well. Dual Image Commands The switch supports a dual image feature that allows the switch to have two software images in the permanent storage. You can specify which image is the active image to be loaded in subsequent reboots. This feature allows reduced down-time when you upgrade or downgrade the software. delete This command deletes the image1 or image 2 file from the permanent storage. The optional unit parameter is valid only for members. The unit parameter identifies the member on which you must execute this command. When you do not enter this parameter, the command is executed on all members in the stack. Format Mode delete [unit] {image1 | image2} Privileged EXEC boot system This command activates the specified image. It will be the active-image for subsequent reboots and will be loaded by the boot loader. The current active-image is marked as the backup-image for subsequent reboots. If the specified image doesn't exist on the system, this command returns an error message. The optional unit parameter identifies the member on which you must execute this command. When you do not enter this parameter, the command is executed on all members in the stack. Format Mode boot system [unit] {image1 | image2} Privileged EXEC Utility Commands 190 CLI Command Reference Manual