Netgear XSM4348CS CLI Manual Software Version 12.x - Page 686
match length, no match ip, address
![]() |
View all Netgear XSM4348CS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 686 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches (NETGEAR Switch) #show mac access-lists Current number of all ACLs: 9 Maximum number of all ACLs: 100 MAC ACL Name Rules Direction Interface(s) madan 1 mohan 1 goud 1 VLAN(s) ---------- (NETGEAR Switch) # (NETGEAR Switch) #configure (NETGEAR Switch) (Config)#route-map madan (NETGEAR Switch) (route-map)#match ip address 1 2 3 4 5 madan (NETGEAR Switch) (route-map)#match mac-list madan mohan goud (NETGEAR Switch) (route-map)#exit (NETGEAR Switch) (Config)#exit (NETGEAR Switch) #show route-map route-map madan permit 10 Match clauses: ip address (access-lists) : 1 2 3 4 5 madan mac-list (access-lists) : madan mohan goud Set clauses: (NETGEAR Switch) (Config)#access-list 2 permit every Request denied. Another application using this ACL restricts the number of rules allowed. (NETGEAR Switch) (Config)#ip access-list madan (NETGEAR Switch) (Config-ipv4-acl)#permit udp any any Request denied. Another application using this ACL restricts the number of rules allowed. no match ip address (for an access list) To delete a match statement for an access list from a route map, use the no match ip address command. Format Mode no match ip address [access-list-number | access-list-name] Route Map Configuration match length Use this command to configure a route map to match based on the Layer 3 packet length between specified minimum and maximum values. min specifies the packet's minimum Layer 3 length, inclusive, allowed for a match. max specifies the packet's maximum Layer 3 length, inclusive, allowed for a match. Each route-map statement can contain one 'match' statement on packet length range. Routing Commands 686 CLI Command Reference Manual
![](/manual_guide/products/netgear-m43008x8f-cli-manual-software-version-12x-6ae8ad6/686.png)