Netgear XSM4348CS CLI Manual Software Version 12.x - Page 447
switchport protected Interface Config, parameter specifies the name to remove from the group.
![]() |
View all Netgear XSM4348CS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 447 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches Note: Port protection occurs within a single switch. Protected port configuration does not affect traffic between ports on two different switches. No traffic forwarding is possible between two protected ports. Default Format Mode unprotected switchport protected groupid name name Global Config no switchport protected (Global Config) Use this command to remove a protected port group. The groupid parameter identifies the set of protected ports. The name parameter specifies the name to remove from the group. Format Mode no switchport protected groupid name name Global Config switchport protected (Interface Config) Use this command to add an interface to a protected port group. The groupid parameter identifies the set of protected ports to which this interface is assigned. You can only configure an interface as protected in one group. Note: Port protection occurs within a single switch. Protected port configuration does not affect traffic between ports on two different switches. No traffic forwarding is possible between two protected ports. Default Format Mode unprotected switchport protected groupid Interface Config no switchport protected (Interface Config) Use this command to configure a port as unprotected. The groupid parameter identifies the set of protected ports to which this interface is assigned. Format Mode no switchport protected groupid Interface Config Switching Commands 447 CLI Command Reference Manual
![](/manual_guide/products/netgear-m43008x8f-cli-manual-software-version-12x-6ae8ad6/447.png)