Netgear XSM4348CS CLI Manual Software Version 12.x - Page 20

M4300 Intelligent Edge Series Fully Managed Stackable Switches Table 5. CLI Command Modes (continued) Command Mode Prompt Mode Description DHCP Pool Config Switch (Config dhcp-pool)# Contains the DHCP server IP address pool configuration commands. DHCPv6 Pool Config Switch (Config dhcp6-pool)# Contains the DHCPv6 server IPv6 address pool configuration commands. Stack Global Config Mode Switch (Config stack)# Allows you to access the Stack Global Config Mode. ARP Access-List Config Mode Switch (Config-arp-access-list)# Contains commands to add ARP ACL rules in an ARP Access List. Support Mode Switch (Support)# Allows access to the support commands, which should only be used by the manufacturer's technical support personnel as improper use could cause unexpected system behavior and/or invalidate product warranty. The following table explains how to enter or exit each mode. Table 6. CLI Mode Access and Exit Command Mode Access Method Exit or Access Previous Mode User EXEC This is the first level of access. To exit, enter logout. Privileged EXEC From the User EXEC mode, enter enable. To exit to the User EXEC mode, enter exit or press Ctrl-Z. Global Config From the Privileged EXEC mode, enter To exit to the Privileged EXEC mode, enter configure. exit, or press Ctrl-Z. VLAN Config From the Privileged EXEC mode, enter To exit to the Privileged EXEC mode, enter vlan database. exit, or press Ctrl-Z. Software Modules 20 CLI Command Reference Manual