Netgear XSM4348CS CLI Manual Software Version 12.x - Page 144

M4300 Intelligent Edge Series Fully Managed Stackable Switches Note: To reconfigure a RADIUS accounting server to use the default UDP port, set the number argument to 1813. Format Mode radius server host {auth | acct} {ipaddr | dnsname} [name servername] [port number] [type server-type] Global Config Field ipaddr dnsname 0-65535 servername server-type Description The IP address of the server. The DNS name of the server. The port number that is used to connect to the specified RADIUS server. The alias name to identify the server. Enter one of the following options: • 0. Specifies a standard server. • 1. Specifies a NETGEAR server. no radius server host The no radius server host command deletes the configured server entry from the list of configured RADIUS servers. If the RADIUS authenticating server being removed is the active server in the servers that are identified by the same server name, then the RADIUS client selects another server for making RADIUS transactions. If the 'auth' token is used, the previously configured RADIUS authentication server is removed from the configuration. Similarly, if the 'acct' token is used, the previously configured RADIUS accounting server is removed from the configuration. The ipaddr or dnsname argument must match the IP address or DNS name of the previously configured RADIUS authentication or accounting server. Format Mode no radius server host {auth | acct} {ipaddr | dnsname} Global Config Command example: (NETGEAR Switch) (Config) #radius server host acct 192.168.37.60 (NETGEAR Switch) (Config) #radius server host acct 192.168.37.60 port 1813 (NETGEAR Switch) (Config) #radius server host auth 192.168.37.60 name Network1_RS port 1813 (NETGEAR Switch) (Config) #radius server host acct 192.168.37.60 name Network2_RS (NETGEAR Switch) (Config) #no radius server host acct 192.168.37.60 Management Commands 144 CLI Command Reference Manual