Netgear XSM4348CS CLI Manual Software Version 12.x - Page 1096

M4300 Intelligent Edge Series Fully Managed Stackable Switches no poe timer schedule name Use this command to detach the schedule from the port. Format Mode no poe timer schedule Interface Config poe usagethreshold Use this command to set a threshold (as a percentage) for the total amount of power that can be delivered by the switch. For example, if the switch can deliver up to a maximum of 300 watts, a usage threshold of 90 percent ensures that only 270 watts are used for delivering power to devices. This ensures that more power is not drawn than the switch can provide. When the usage threshold is set, all the PDs are brought down and then brought back up. If the consumed power is less than the threshold power (in the preceding case, 270 watts), then the devices continue to power up. If the consumed power is 269 watts or less, the next device is powered up. The moment consumed power exceeds the threshold power (270 watts), no other devices can power up. This command allows you to set the usage threshold based on each individual PoE unit or all PoE units. Default Format Mode 90 poe usagethreshold {unit | all} percentage Global Config no poe usagethreshold Use this command to set the usage threshold to a default value. Format Mode no poe usagethreshold {unit | all} Global Config poe traps Use this command to enable logging of specific PoE-related events, such as a PoE port powering a device, the threshold being exceeded, and so on. Default Format Mode Enabled poe traps Global Config Power over Ethernet Commands 1096 CLI Command Reference Manual