Netgear XSM4348CS CLI Manual Software Version 12.x - Page 978
The value specified IP Precedence., Ending Source L4 port
View all Netgear XSM4348CS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 978 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches Term Rule Number Action Match All Protocol ICMP Type Starting Source L4 port Ending Source L4 port Starting Destination L4 port Ending Destination L4 port ICMP Code Fragments Committed Rate Committed Burst Size Source IP Address Source IP Mask Source L4 Port Keyword Destination IP Address Destination IP Mask Destination L4 Port Keyword IP DSCP IP Precedence IP TOS Log Assign Queue Mirror Interface Redirect Interface Time Range Name Definition The number identifier for each rule that is defined for the IP ACL. The action associated with each rule. The possible values are Permit or Deny. Indicates whether this access list applies to every packet. Possible values are True or False. The protocol to filter for this rule. Note: This is shown only if the protocol is ICMP. The ICMP message type for this rule. The starting source layer 4 port. The ending source layer 4 port. The starting destination layer 4 port. The ending destination layer 4 port. Note: This is shown only if the protocol is ICMP. The ICMP message code for this rule. If the ACL rule matches on fragmented IP packets. The committed rate defined by the rate-limit attribute. The committed burst size defined by the rate-limit attribute. The source IP address for this rule. The source IP Mask for this rule. The source port for this rule. The destination IP address for this rule. The destination IP Mask for this rule. The destination port for this rule. The value specified for IP DSCP. The value specified IP Precedence. The value specified for IP TOS. Displays when you enable logging for the rule. The queue identifier to which packets matching this rule are assigned. The unit/slot/port to which packets matching this rule are copied. The unit/slot/port to which packets matching this rule are forwarded. Displays the name of the time-range if the IP ACL rule has referenced a time range. Quality of Service Commands 978 CLI Command Reference Manual