Netgear XSM4348CS CLI Manual Software Version 12.x - Page 583
set mld groupmembership-interval, set mld maxresponse, value. The range is 2 to 3600 seconds.
View all Netgear XSM4348CS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 583 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches Note: Fast-leave processing is supported only with MLD version 1 hosts. Default Format Mode Enabled for VLAN 1; Disabled for other VLANs. set mld fast-leave vlan-id Interface Config VLAN Mode no set mld fast-leave Use this command to disable MLD Snooping fast-leave admin mode on a selected interface. Format Mode no set mld fast-leave vlan-id Interface Config VLAN Mode set mld groupmembership-interval Use this command to set the MLD Group Membership Interval time on a VLAN, one interface or all interfaces. The Group Membership Interval time is the amount of time in seconds that a switch waits for a report from a particular group on a particular interface before deleting the interface from the entry. This value must be greater than the MLDv2 maximum response time value. The range is 2 to 3600 seconds. Default Format Mode 260 seconds set mld groupmembership-interval vlan-id seconds Interface Config Global Config VLAN Mode no set groupmembership-interval Use this command to set the MLDv2 group membership Interval time to the default value. Format Mode no set mld groupmembership-interval Interface Config Global Config VLAN Mode set mld maxresponse Use this command to set the MLD maximum response time for the system, on a particular interface or VLAN. The maximum response time is the amount of time in seconds that a Switching Commands 583 CLI Command Reference Manual