Netgear XSM4348CS CLI Manual Software Version 12.x - Page 619
dos-control sipdip, dos-control firstfrag
![]() |
View all Netgear XSM4348CS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 619 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches no dos-control all This command disables Denial of Service prevention checks globally. Format Mode no dos-control all Global Config dos-control sipdip This command enables Source IP address = Destination IP address (SIP = DIP) Denial of Service protection. If the mode is enabled, Denial of Service prevention is active for this type of attack. If packets ingress with SIP = DIP, the packets will be dropped if the mode is enabled. Default Format Mode disabled dos-control sipdip Global Config no dos-control sipdip This command disables Source IP address = Destination IP address (SIP = DIP) Denial of Service prevention. Format Mode no dos-control sipdip Global Config dos-control firstfrag This command enables Minimum TCP Header Size Denial of Service protection. If the mode is enabled, Denial of Service prevention is active for this type of attack. If packets ingress having a TCP Header Size smaller then the configured value, the packets will be dropped if the mode is enabled. The default is disabled. The range is 0-255. If you enable dos-control firstfrag, but do not provide a Minimum TCP Header Size, the system sets that value to 20. Default Format Mode disabled (20) dos-control firstfrag [size] Global Config Switching Commands 619 CLI Command Reference Manual
![](/manual_guide/products/netgear-m43008x8f-cli-manual-software-version-12x-6ae8ad6/619.png)