Netgear XSM4348CS CLI Manual Software Version 12.x - Page 1112

M4300 Intelligent Edge Series Fully Managed Stackable Switches Switching Table 37. Protected Ports Log Messages Component Protected Ports Protected Ports Protected Ports Protected Ports Protected Ports Protected Ports Protected Ports Protected Ports Message Cause Protected Port: failed to save configuration This appears when the protected port configuration cannot be saved. protectedPortCnfgrInitPhase1Process: Unable to This appears when protectedPortCfgRWLock create r/w lock for protected Port Fails. protectedPortCnfgrInitPhase2Process: Unable to This appears when nimRegisterIntfChange with register for VLAN change callback VLAN fails. Cannot add interface xxx to group yyy This appears when an interface could not be added to a particular group. unable to set protected port group This appears when a dtl call fails to add interface mask at the driver level. Cannot delete interface xxx from group yyy This appears when a dtl call to delete an interface from a group fails. Cannot update group YYY after deleting interface This message appears when an update group for XXX a interface deletion fails. Received an interface change callback while not This appears when an interface change call back ready to receive it has come before the protected port component is ready. Table 38. IP Subnet VLANS Log Messages Component IP subnet VLANs IP subnet VLANs IP subnet VLANs IP subnet VLANs IP subnet VLANs IP subnet VLANs Message Cause ERROR vlanIpSubnetSubnetValid:Invalid subnet This occurs when an invalid pair of subnet and netmask has come from the CLI. IP Subnet Vlans: failed to save configuration This message appears when save configuration of subnet vlans failed. vlanIpSubnetCnfgrInitPhase1Process: Unable to This appears when a read/write lock creations create r/w lock for vlanIpSubnet fails. vlanIpSubnetCnfgrInitPhase2Process: Unable to This appears when this component unable to register for VLAN change callback register for vlan change notifications. vlanIpSubnetCnfgrFiniPhase1Process: could not This appears when a semaphore deletion of this delete avl semaphore component fails. vlanIpSubnetDtlVlanCreate: Failed This appears when a dtl call fails to add an entry into the table. Switch Software Log Messages 1112 CLI Command Reference Manual