Netgear XSM4348CS CLI Manual Software Version 12.x - Page 132

M4300 Intelligent Edge Series Fully Managed Stackable Switches no snmp-server trapsend Use this command to reset the UDP port to which traps are sent by the SNMP server to the default port of 50505. Format Mode no snmp-server trapsend Global Config snmptrap This command adds an SNMP trap receiver. The snmpversion parameter is the version of SNMP. The version parameter option can be snmpv1 or snmpv2. You can set the SNMP trap address as an IPv4 or IPv6 global address. The name parameter does not need to be unique, however; the combination of name and ipaddr or ip6addr must be unique. Multiple entries can exist with the same name as long as they are associated with a different ipaddr or ip6addr. The reverse scenario is also acceptable. The name is the community name used when sending the trap to the receiver, but the name is not directly associated with the SNMP Community table (see snmp-server community on page 127). Default Format Mode snmpv2 snmptrap name {ipaddr ipaddr | ip6addr ip6addr} [snmpversion snmpversion] Global Config Command example: (NETGEAR Switch)# snmptrap mytrap ip6addr 3099::2 no snmptrap This command delete trap receivers for a community. Format Mode no snmptrap name {ipaddr ipaddr | ip6addr ip6addr} Global Config snmptrap snmpversion This command modifies the SNMP version of a trap. The maximum length of the name parameter is 16 case-sensitive alphanumeric characters. The snmpversion parameter options are snmpv1 or snmpv2. Note: This command does not support a no form. Management Commands 132 CLI Command Reference Manual