Netgear XSM4348CS CLI Manual Software Version 12.x - Page 82
permit ip-source, permit service, no management access-list
View all Netgear XSM4348CS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 82 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches \ Format Mode management access list name Global Config no management access-list This command deletes a management ACL identified by the name parameter. Format Mode no management access list name Global Config permit ip-source This command sets permit conditions for the management access list based on the source IP address of a packet. Optionally, you can specify a subnet mask, service type, priority, or a combination of these for the rule. Each rule requires a unique priority. Use this command in Management access-list configuration mode. Format Mode permit ip-source ip-address [mask {mask | prefix-length}] [service service] [priority priority] Management access-list configuration Parameter ip-address mask prefix-length service priority Definition The source IP address. The network mask of the source IP address. Specifies the number of bits that comprise the source IP address prefix. The prefix length must be preceded by a forward slash (/). Indicates the service type: telnet, ssh, http, https, or snmp. The priority for the rule. permit service This command sets permit conditions for the management access list based on the access protocol. Each rule requires a unique priority. Use this command in Management access-list configuration mode. Format Mode permit service service [priority priority] Management access-list configuration Management Commands 82 CLI Command Reference Manual