Netgear XSM4348CS CLI Manual Software Version 12.x - Page 444
Provisioning (IEEE 802.1p) Commands
![]() |
View all Netgear XSM4348CS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 444 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches Term Definition Configured Mode The configuration status of the PTP E2E transparent clock on the interface Operational Mode The operational status of the PTP E2E transparent clock on the interface. Command example: (NETGEAR Switch) #show ptp clock e2e-transparent PTP TC mode Enabled Interface --------1/1/1 1/1/2 1/1/3 1/1/4 1/1/5 1/1/6 1/1/7 1/1/8 Configured Mode Operational Mode Enabled Disabled Enabled Disabled Enabled Disabled Enabled Disabled Enabled Disabled Enabled Disabled Enabled Disabled Enabled Disabled Provisioning (IEEE 802.1p) Commands This section describes the commands you use to configure provisioning (IEEE 802.1p,) which allows you to prioritize ports. vlan port priority all This command configures the port priority assigned for untagged packets for all ports presently plugged into the device. The range for the priority is 0-7. Any subsequent per port configuration will override this configuration setting. Format Mode vlan port priority all priority Global Config vlan priority This command configures the default 802.1p port priority assigned for untagged packets for a specific interface. The range for the priority is 0-7. Default Format Mode 0 vlan priority priority Interface Config Switching Commands 444 CLI Command Reference Manual
![](/manual_guide/products/netgear-m43008x8f-cli-manual-software-version-12x-6ae8ad6/444.png)