Netgear XSM4348CS CLI Manual Software Version 12.x - Page 324

M4300 Intelligent Edge Series Fully Managed Stackable Switches Parameter Description Receiver Owner The identity string for the receiver, the entity making use of this sFlowRcvrTable entry. The range is 127 characters. The default is a null string. The empty string indicates that the entry is currently unclaimed and the receiver configuration is reset to the default values. An entity wishing to claim an sFlowRcvrTable entry must ensure that the entry is unclaimed before trying to claim it. The entry is claimed by setting the owner string to a non-null value. The entry must be claimed before assigning a receiver to a sampler or poller. Receiver Timeout The time, in seconds, remaining before the sampler or poller is released and stops sending samples to receiver. A management entity wanting to maintain control of the sampler is responsible for setting a new value before the old one expires. The allowed range is 0-2147483647 seconds. The default is zero (0). No Timeout The configured entry will be in the config until you explicitly removes the entry. Receiver Max Datagram Size The maximum number of data bytes that can be sent in a single sample datagram. The management entity should set this value to avoid fragmentation of the sFlow datagrams. The allowed range is 200 to 9116). The default is 1400. Receiver IP The sFlow receiver IP address. If set to 0.0.0.0, no sFlow datagrams will be sent. The default is 0.0.0.0. Receiver Port The destination Layer4 UDP port for sFlow datagrams. The range is 1-65535. The default is 6343. no sflow receiver Use this command to set the sFlow collector parameters back to the defaults. Format Mode no sflow receiver rcvr_idx [owner | maxdatagram | ip | port] Global Config sflow receiver owner timeout Use this command to configure a receiver as a timeout entry. As the sFlow receiver is configured as a timeout entry, information related to sampler and pollers are also shown in the running-config and are retained after reboot. If a receiver is configured with a specific value, these configurations are not shown in the running-config file. Samplers and pollers information related to this receiver are also not shown in the running-config file. Format Mode sflow receiver index owner owner-string timeout Global Config Utility Commands 324 CLI Command Reference Manual