Netgear XSM4348CS CLI Manual Software Version 12.x - Page 896

M4300 Intelligent Edge Series Fully Managed Stackable Switches show ipv6 ospf max-metric This command displays the configured maximum metrics for stub-router mode. Format Modes show ipv6 ospf max-metric Privileged EXEC User EXEC Command example: (config)#show ipv6 ospf max-metric OSPFv3 Router with ID (3.3.3.3) Start time: 00:00:00, Time elapsed: 00:01:05 Originating router-LSAs with maximum metric Condition: on startup for 1000 seconds, State: inactive Advertise external-LSAs with metric 16711680 show ipv6 ospf neighbor This command displays information about OSPF neighbors. If you do not specify a neighbor IP address, the output displays summary information in a table. If you specify an interface or tunnel, only the information for that interface or tunnel displays. The argument unit/slot/port corresponds to a physical routing interface or VLAN routing interface. The vlan keyword and vlan-id parameter are used to specify the VLAN ID of the routing VLAN directly instead of in a unit/slot/port format. The vlan-id can be a number from 1-4093. You can also use the tunnel keyword with the tunnel-id argument to specify a tunnel. The ip-address is the IP address of the neighbor, and when you specify this, detailed information about the neighbor displays. The information displays only if OSPF is enabled and the interface has a neighbor. Format Modes show ipv6 ospf neighbor [interface {unit/slot/port | vlan vlan-id | tunnel tunnel-id}] [ip-address] Privileged EXEC User EXEC If you do not specify an IP address, a table with the following columns displays for all neighbors or the neighbor associated with the interface that you specify. Term Router ID Priority Intf ID Definition The 4-digit dotted-decimal number of the neighbor router. The OSPF priority for the specified interface. The priority of an interface is a priority integer from 0 to 255. A value of 0 indicates that the router is not eligible to become the designated router on this network. The interface ID of the neighbor. IPv6 Commands 896 CLI Command Reference Manual