Netgear XSM4348CS CLI Manual Software Version 12.x - Page 946
mark ip-dscp, mark ip-precedence, police-simple, police, set-dscp-transmit
![]() |
View all Netgear XSM4348CS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 946 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches Command example: (NETGEAR Switch) (Config-policy-classmap)#mark cos-as-sec-cos mark ip-dscp This command marks all packets for the associated traffic stream with the specified IP DSCP value. The dscpval value is specified as either an integer from 0 to 63, or symbolically through one of the following keywords: af11, af12, af13, af21, af22, af23, af31, af32, af33, af41, af42, af43, be, cs0, cs1, cs2, cs3, cs4, cs5, cs6, cs7, or ef. Format Mode Incompatibilities mark ip-dscp dscpval Policy-Class-Map Config Drop, Mark CoS, Mark IP Precedence, Police mark ip-precedence This command marks all packets for the associated traffic stream with the specified IP Precedence value. The IP Precedence value argument is an integer from 0 to 7. Note: This command may not be used on IPv6 classes. IPv6 does not have a precedence field. Format Mode Incompatibilities Policy Type mark ip-precedence value Policy-Class-Map Config Drop, Mark CoS, Mark IP Precedence, Police In police-simple This command is used to establish the traffic policing style for the specified class. The simple form of the police command uses a single data rate and burst size, resulting in two outcomes: conform and violate. The conforming data rate is specified in kilobits-per-second (Kbps) and is an integer from 1 to 4294967295. The conforming burst size is specified in kilobytes (KB) and is an integer from 1 to 128. For each outcome, the only possible actions are drop, set-cos-as-sec-cos, set-cos-transmit, set-sec-cos-transmit, set-dscp-transmit, set-prec-transmit, or transmit. In this simple form of the police command, the conform action defaults to transmit and the violate action defaults to drop. These actions can be set with this command once the style is configured. For set-dscp-transmit, a value is required and is specified as either an integer from 0 to 63, or symbolically through one of the following keywords: af11, af12, af13, af21, af22, Quality of Service Commands 946 CLI Command Reference Manual
![](/manual_guide/products/netgear-m43008x8f-cli-manual-software-version-12x-6ae8ad6/946.png)