Netgear XSM4348CS CLI Manual Software Version 12.x - Page 1069
show ipv6 pim ssm, show ipv6 pim interface
![]() |
View all Netgear XSM4348CS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1069 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches Command example: The following example displays PIM Mode - Sparse: (NETGEAR) #show ipv6 pim PIM Mode Sparse Interface --------1/0/1 1/0/3 Interface-Mode Enabled Disabled Operational-Status Operational Non-Operational Command example: The following example shows that PIM is not configured: (NETGEAR) #show ipv6 pim PIM Mode None None of the routing interfaces are enabled for PIM. show ipv6 pim ssm This command displays the configured source specific IPv6 multicast addresses. If no SSM Group range is configured, the command output show the following message: No SSM address range is configured. Format Modes show ipv6 pim ssm Privileged EXEC User EXEC Term Group Address Prefix Length Definition The IPv6 multicast address of the SSM group. The network prefix length. show ipv6 pim interface This command displays the interface information for PIM on the specified interface. The argument unit/slot/port corresponds to a physical routing interface or VLAN routing interface. The vlan keyword and vland-id parameter are used to specify the VLAN ID of the routing VLAN directly instead of in the unit/slot/port format. The vlan-id parameter is a number in the range of 1-4093. IPv6 Multicast Commands 1069 CLI Command Reference Manual
![](/manual_guide/products/netgear-m43008x8f-cli-manual-software-version-12x-6ae8ad6/1069.png)