Netgear XSM4348CS CLI Manual Software Version 12.x - Page 466

M4300 Intelligent Edge Series Fully Managed Stackable Switches Each method can only be entered once. Ordering is only possible between 802.1x and MAB. Captive portal can be configured either as a stand-alone method or as the last method in the order. Format Mode authentication order {dot1x [mab [captive-portal] | captive-portal] | mab [dot1x [captive-portal]| captive-portal] | captive-portal} Interface Config no authentication order This command returns the port to the default authentication order. Format Mode no authentication order Interface Config authentication priority This command sets the priority for the authentication methods used on a port. The available authentication methods are Dot1x, MAB, and captive portal. The authentication priority decides if a previously authenticated client is reauthenticated with a higher-priority method when the same is received. Captive portal is always the last method in the list. Default Format Mode authentication order dot1x mab captive portal authentication priority {dot1x [mab [captive portal] | captive portal] | mab [dot1x [captive portal]| captive portal] | captive portal} Interface Config no authentication priority This command returns the port to the default order of priority for the authentication methods. Format Mode no authentication priority Interface Config authentication restart This command sets the time, in seconds, after which reauthentication starts. The range is 300-65535 seconds and the default time is 300 seconds. The timer restarts the authentication only after all the authentication methods fail. At the expiration of this timer, authentication is reinitiated for the port. Format Mode authentication restart seconds Interface Config Switching Commands 466 CLI Command Reference Manual