Netgear XSM4348CS CLI Manual Software Version 12.x - Page 462
dot1x re-authenticate, dot1x system-auth-control, no dot1x mac-auth-bypass
![]() |
View all Netgear XSM4348CS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 462 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches no dot1x mac-auth-bypass This command sets the MAB mode on the ports to the default value. Format Mode no dot1x mac-auth-bypass Interface Config dot1x re-authenticate This command begins the reauthentication sequence on the specified port. This command is only valid if the control mode for the specified port is auto or mac-based. If the control mode is not auto or mac-based, an error is returned. Format Mode dot1x re-authenticate unit/slot/port Privileged EXEC dot1x re-authentication This command enables reauthentication of the supplicant for the specified interface or range of interfaces. Default Format Mode Disabled dot1x re-authentication Interface Config no dot1x re-authentication This command disables reauthentication of the supplicant for the specified port. Format Mode no dot1x re-authentication Interface Config dot1x system-auth-control Use this command to enable the dot1x authentication support on the switch. While disabled, the dot1x configuration is retained and can be changed, but is not activated. Default Format Mode Disabled dot1x system-auth-control Global Config Switching Commands 462 CLI Command Reference Manual
![](/manual_guide/products/netgear-m43008x8f-cli-manual-software-version-12x-6ae8ad6/462.png)