Netgear XSM4348CS CLI Manual Software Version 12.x - Page 189

M4300 Intelligent Edge Series Fully Managed Stackable Switches Transmit Packets Discarded 0 Transmit Packet Errors 0 Collision Frames 0 Time Since Counters Last Cleared 281 day 4 hr 9 min 0 sec Command example: (NETGEAR Switch) #show interface 0/1 | exclude "Packets" Transmit Packet Errors 0 Collision Frames 0 Time Since Counters Last Cleared 20 day 21 hr 30 min 9 sec show "command" | begin "string" The command show command (that is, you must enter a keyword of an existing show command for the command parameter) is executed and the output is filtered to show all lines beginning with and following the first line containing the string match. All prior lines are suppressed. Command example: (NETGEAR Switch) #show port all | begin "1/1" 1/1 Enable 1/2 Enable 1/3 Enable 1/4 Enable 1/5 Enable 1/6 Enable Down Disable N/A N/A Down Disable N/A N/A Down Disable N/A N/A Down Disable N/A N/A Down Disable N/A N/A Down Disable N/A N/A show "command" | section "string" The command show command (that is, you must enter a keyword of an existing show command for the command parameter) is executed and the output is filtered to show only lines included within the section(s) identified by lines containing the string match and ending with the first line containing the default end-of-section identifier (that is, exit). Command example: (NETGEAR Switch) #show running-config | section "interface 0/1" interface 0/1 no spanning-tree port mode exit Utility Commands 189 CLI Command Reference Manual