Netgear XSM4348CS CLI Manual Software Version 12.x - Page 952

M4300 Intelligent Edge Series Fully Managed Stackable Switches If the Policy Name is specified the following fields are displayed. Term Policy Name Policy Type Class Members Definition The name of this policy. The policy type (only inbound policy definitions are supported for this platform.) The class that is a member of the policy. The following information is repeated for each class associated with this policy (only those policy attributes actually configured are displayed). Term Definition Assign Queue Directs traffic stream to the specified QoS queue. This allows a traffic classifier to specify which one of the supported hardware queues are used for handling packets belonging to the class. Class Name The name of this class. Committed Burst The committed burst size, used in simple policing. Size (KB) Committed Rate (Kbps) The committed rate, used in simple policing. Conform Action The current setting for the action taken on a packet considered to conform to the policing parameters. This is not displayed if policing is not in use for the class under this policy. Conform Color Mode The current setting for the color mode. Policing uses either color blind or color aware mode. Color blind mode ignores the coloration (marking) of the incoming packet. Color aware mode takes into consideration the current packet marking when determining the policing outcome. Conform COS The CoS mark value if the conform action is set-cos-transmit. Conform DSCP Value The DSCP mark value if the conform action is set-dscp-transmit. Conform IP The IP Precedence mark value if the conform action is set-prec-transmit. Precedence Value Drop Drop a packet upon arrival. This is useful for emulating access control list operation using DiffServ, especially when DiffServ and ACL cannot co-exist on the same interface. Exceed Action The action taken on traffic that exceeds settings that the network administrator specifies. Exceed Color Mode The current setting for the color of exceeding traffic that the user may optionally specify. Mark CoS The class of service value that is set in the 802.1p header of inbound packets. This is not displayed if the mark cos was not specified. Mark CoS as Secondary CoS The secondary 802.1p priority value (second/inner VLAN tag. Same as CoS (802.1p) marking, but the dot1p value used for remarking is picked from the dot1p value in the secondary (i.e. inner) tag of a double-tagged packet. Mark IP DSCP The mark/re-mark value used as the DSCP for traffic matching this class. This is not displayed if mark ip description is not specified. Quality of Service Commands 952 CLI Command Reference Manual